LIMITED TIME ONLY! 10% OFF US WATER RESIDENTIAL PRODUCTS | USE COUPON: waterquality17
Mon-Fri 8am - 8pm | Sat 9am-3pm EDT
Se habla español
SHOP
Mon-Fri 8am - 8pm | Sat 9am-3pm EDT
LIMITED TIME ONLY! + 10% OFF US WATER RESIDENTIAL PRODUCTS | USE COUPON: waterquality17

Harmsco Fusion Bonded Coated Housings

Designed to Resist Sea Water, Waste Water and Harsh coatedharmscohousingsgroupshot.pngChemicals

These single cartridge housings feature a 3M fusion bonded epoxy coating for resistance to sea water, waste water and harsh chemicals. The coating has been tested and certified to ANSI/NSF Standard 61, Drinking Water Systems Components and meets the requirements of AWWA Standard C213 and C550.

Features

✔ Excellent chemical resistance
✔ Resists cavitation and cathodic disbondment
✔ High adhesion and toughness
✔ Protects over a wide temperature range
✔ Lightweight for lower shipping cost
✔ Coating certified to ANSI/NSF Standard 61
✔ Meets requirements of AWWA Standard C213 and C550

Applications

✔ Desalination Pre-filtration
✔ Industrial Waste Water Treatment
✔ Environmental Compliance
✔ Marine /Aquatic Filtration
✔ Brackish Water Filtration
✔ Chemical Solvent Filtration
✔ Plating Solutions
✔ Process Water Filtration

Advantages

Harmsco Coated Housings

 

Specifications

pH: 5 - 12
(dependent on temperature and compound)
Thickness: 6 - 10 mil
Temperature*: Up to 175˚F (79˚C)
Color: Forest green

Note: This publication is to be used as a guide. The data within has been obtained from many sources and is considered to be accurate. Harmsco does not assume liability for the accuracy and/or completeness of this data. Changes to the data can be made without notification. Temperature, Pressure, Flow Rates, Differential Pressures, Chemical Combinations and other unknown factors can affect performance in unknown ways. Limited Warranty: Harmsco warrants their products to be free of material and workmanship defects. Determination of suitability of Harmsco products for uses and applications contemplated by Buyer shall be the sole responsibility of Buyer. The end user/installer/buyer shall be liable for the product’s performance and suitability regarding their specific intended applications. End users should perform their own tests to determine suitability for each application.